Friday, September 25, 2015

WIP: Original Figure Sculpt Part 3

Been while since my last update.  Been busy!

But here is progress so far.  I've decided to sell this as a garage kit at Designercon in November!

Making the Boots:

Here is also a way to align a pin on two parts without doing any sort of drilling through.  You mark off on the outside 4 lines around the piece so you can draw the line over the cut.  The resulting 'X'  will give you a matching point to drill on each side.

Here is a Step by step on her vest.

Work on her hands

Cut offs!

Next is work on her hair. 

Decided to change the pose of her left hand to make it a little more dynamic.  Here is the refinement process:

Almost done!